• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

AMbient temp is 70, UTH is at 86

Y

yvez9

New member
Is 70 hot enough for the ambient air, also the cool side will be around 70 as well. The UTH shows 87 right above it on the glass. Should I get something to heat up the ambien air or is that enough? The temperature dropped a lot since last week here so it's pretty cool outside all of a sudden and we haven't turned up the heat inside as it is not really cold either, but we're no snake...
 
Your corn won't care as much about the air temp as he does the substrate (belly) temp. Make sure the "warm" side is between 80-85 and the cool side is between 70-75. In the winter time, my cool side drops to about 60-65, so I supplement it with a heat lamp, and that brings it up to 70.

I would say your temps are fine. If your snake thinks the air is too chilly, he will curl up in a hide on the warm side, or bury himself.
 
Agreed. Unless you have shelves or climbing equipment where your Corn usually spends his time, measuring temps above ground level is a waste of effort. The temp at ground level is the key.

I wouldn't worry unless your Corn starts to spend a lot of time down the warm end, when he doesn't usually do that.
 
Thanks for the info
well he's usually found hiding under the big branch which is on the cool side
at night i see him moving around and exploring everything.

I've tried to feed him this morning but he showed no interest
I'll try again tomorrow night!
 
Well well, the little bugger disappeared this afternoon

I'm pretty sure he managed to fit inside the piece of wood I ahve there. I can see little holes but not far enough to see where they lead. I've emptied out the whole aquarium and he's nowhere to be seen. The lid was locked so I can't see how he would've escaped...

Any trick on getting a snake out of a log?
 
This happened to another member not too long ago. I'd say to make the temperature of the log the opposite of what it was before. Meaning, if it was on the cool side, the snake preferred that, so make it warmer (trying to drive the snake out).

Or, you could wait it out, and check back tonight when it is most likely to be active.
 
Seeing how the log is quite bulky, I doubt just putting it above the UTH would warm it up enough to make a real difference. I'll wait it out a day or two and see if it will come out on its own. My biggest fear is that the snake will be stuck in there :shrugs:
 
I tried the heat trick anyway
I put the log on the warm side and cranked up the rheostat a little bit
I'll try to get it closer to 86-87 on the ground....
 
I also suggest that when you get the snake out, remove the log until the snake is too big to get back into the holes.
 
yvez9 said:
Well well, the little bugger disappeared this afternoon

I'm pretty sure he managed to fit inside the piece of wood I ahve there. I can see little holes but not far enough to see where they lead. I've emptied out the whole aquarium and he's nowhere to be seen. The lid was locked so I can't see how he would've escaped...

Any trick on getting a snake out of a log?
Click to expand...

Sounds familiar! My hatchling spent his first two days at our house hidden in the hollow core of an artificial log hide. My tank temps were almost identical to yours, but my log had been on the warm side. Since I was extremely concerned to know if he was hiding in there or had somehow escaped from a pretty secure viv, I decided to make the log less attractive by cooling it down. First I moved the log to the cool side. Then I laid a frozen cooler (inside a ziploc bag) right up against the branch where I hoped he was hiding. This drove him down into the larger part of the log where I could see him, and eventually I was able to remove him from the log.

Good Luck!
 
Good news
As I expected, the snake came out of his hide about 30 minutes after lights out. He's always roaming around the tank when the light goes off and I was hoping we'd see him :D

All is good
I won't remove the log since he only has 2 places to hide and that log is pretty much his favorite

I'll try feeding him tomorrow night so I'll put everything back the way it was when I do!
 
You must log in or register to reply here.
Back
Top