• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

Designing my Rack

coxy1130

coxy1130

New member
Ok so I'm guessing that a lot of you breeders have racks to house your various snakes. I'm designing my own as I would like to join the ranks of you wonderful people and was just wondering if you could take a few minutes out of your day to post up pics of your racks and the boxes/containers/vivs etc. that you use to house your various sizes of animals.

Also if you could post shelf dimensions and exterior dimensions that would be great.

Cheers Guys
 
da bnawn coxy fel ach 'm Cymraeg chyfaill..
That'll stump the others... LOL... (My national language)

Just go to no frills and pick up the bins you need. Then place the shelves exactly the same width apart as the depth of the bin (that way the shelves act as lids, and makes it easier to get to your snakes)
I'll look through our photobucket later and pull out a pic of ours....
 
Here is a couple of mine, I made them out of melamine. every board is 3'x2' and I just started at the bottom and worked my way up. the tubs are 32 and 28 qt.
DSCN2867.jpg

DSCN2895.jpg

DSCN2893.jpg


And oh yes,.... the tubs are now all filled!! :)
 
Forgot to mention I have some additional pics as we were building it on my Reptilegeeks.com page. my username there is also manofcornsnakes. check out my gallery pics, should give you a good idea. any questions, just drop me a line.
Enjoy the building process, don't rush, I had a great time building them. To give you an Idea on cost, the 7' 24 tub rack cost me about $300.00 to make and that included the price of the tubs. I got the 3/4 inch melamine at Home depot and used the coarse thread drywall screws. TAKE THE TIME TO PRE-DRILL THE SCREW HOLES- :)
 
You must log in or register to reply here.
Back
Top