• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

Finally Finished

S

SuZZieWhoQ

New member
Well it took me 2 weeks to get it done. Just no time to work on it but they are finished now. Hope you like.

SuZZie

P1010019.jpg

Front View

P1010020.jpg

Back View

frontview.jpg

Front View

P1010022.jpg

Back View

complete.jpg

The bottom tank will be housing to crested Geckos In Aug.

Sorry for the dirty glass. My kids like to put the hands all over it.
 
I like the idea of using glass on both sides. It works as a room divider. Original.
I have a few questions if you don't mind. I'm planning on make my own Viv too. First, it looks like your using sliding glass doors, if so are the door glides 3/4" thick. To "sit" on a piece on 3/4" edge of wood?
Second, I not sure how I'm going to heat my wooden Viv,v what are you using and how?.

Thanks for your picture and any replies

Lennycorn
 
I am using a heat mat you could use heat tape they just don't sell it here. I am using a temperature adjuster on it cause with out it the temp gets to high. I then got a ceramic tile for 95 cents and placed it over the heat mat. Drilled a hole in the bottom for the wires. The hole was then covered up by the tile. I siliconed around the tile to make sure there was not rough edges.
I went to a glass recycle place and got my 3mm tempered glass. I paid 5 bucks a panel. It is sitting on 3/4" lat. The door glides are 5/8". It would depend on how thick your glass is.
You can get the plastic sliding glass holder at Rona or home depot. They were 12 bucks for 12 feet. I also mounted lights inside on the tops just to lighten them up.

Suzzie
 
You must log in or register to reply here.
Back
Top