• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

front loading tank, thread.

xreinx

xreinx

New member
http://www.cornsnakes.com/forums/showthread.php?t=77387

Thanks to all the peoples who gave me these Ideas! the biggest trouble I had was with the thickness of the plexy glass. (recommend 1/4 thickness) otherwise your going to waste money and have extra glass laying around then you know what your going to do with... yea..
 

Attachments

  • 100_4640.JPG
    100_4640.JPG
    107 KB · Views: 140
Last edited:
Haha, I just learned that too. I had a drawing and parts list for a great double viv, so I went to the parts store. When I picked up the .100 plexi, it was obvious I would have to go thicker, which they didn't sell in a good size. So I put the four things back from the cart and headed home to check the web.

1/4 inch is thick enough for a lid, in your opinion? They had .200, which felt pretty good.
 
yea I had to go back after the thin stuff cracked when I tried to put the latch in, and when I tightened the screws down for the hinge, it suddinly cracked in half, wasent my best moment, and now I have two extra sets of plexi that arent good for Anything.. annoying as heck.

what I did, was I measured the top and had them cut it at the store, it works good, you dont have any shaveings to deal with, and the people, as confused as they can get, do try to help you.
 
You must log in or register to reply here.
Back
Top