• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

heat question

roswald

roswald

New member
Hello i have read that the temps should taken on top of the substrate.
My corn spends 85% of his time beneath the aspen, so should I be going by the temp. on the viv floor where the uth is? I would hate to think I was doin something wrong that may injure him. thank you.
 
Temps should be taken at the hottest point that the snake could touch.
I think that point would be on the glass above the the UTH.
 
Lennycorn said:
Temps should be taken at the hottest point that the snake could touch.
I think that point would be on the glass above the the UTH.
Click to expand...
Yup...I agree. If your snake can get to it and rest on it, THAT should be where the temperature is taken, so as to prevent ventral burns from resting on a UTH that is too hot...
 
You must log in or register to reply here.
Back
Top