• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

Interdesign hatchling racks?

TyeW

TyeW

New Breeder
Hi there, I was just looking at the reptile basics interdesign hatchling racks and was wondering if anybody has any feedback on them. It seems to me like the tubs would be too small to hold any hatchling corn for longer than a month... The tubs are 12" x 3" x 2" and the rack is made of PVC with the new 12" THG heat tape along the back.
http://www.reptilebasics.com/interdesign-32-or-68-tub-rack

I am open to suggestions on other hatchling rack ideas as well, as I am looking to either buy or make a larger one this winter for the upcoming babies. I am not looking for the classic racks with 6 quart tubs as I have found these to be too big for my hatchling corns to want to feed and have had more success with smaller containers.
 
You must log in or register to reply here.
Back
Top