• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

Making a Lid

E

ekans

New member
I'm getting a corn snake soon, and have the tank I need and all the supplies almost ready. I was going to buy a Zilla lid for my tank, but found out that the dimensions are all wrong and it's not a perfect rectangle, either. I'd rather make my own screen lid than buy a new tank.

Anyone know how?
 
ekans said:
I'm getting a corn snake soon, and have the tank I need and all the supplies almost ready. I was going to buy a Zilla lid for my tank, but found out that the dimensions are all wrong and it's not a perfect rectangle, either. I'd rather make my own screen lid than buy a new tank.

Anyone know how?
Click to expand...

Hey ekans,

Answer to your question is YES with 2x2s and 1x4s and wire screen and stables.

Love the Fatman
 
After looking at the lid, I've decided it would be best simply to modify it. It has holes in the plastic, though, for tubes (it was a fish tank) and a rectangular opening at the top. How would I attach mesh to plastic?
 
You must log in or register to reply here.
Back
Top