• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

Mini-Rack, Schematic Diagrams

rsegerberg

New member
A few people have expressed interest in the plans for my Mini-rack,
So here they are, Hope it helps, and if you have any questions
Let me know.

Supplies:
1) 1pc - 4'x8'x5/8" white melamine board - 40.00
2) 1pc - 2'x4'x3/16" white pegboard - $10.00
3) 2pc - Sterilite 16"x11" tub - $8.00
4) 2pc - Sterilite 16"x22" tub - $12.00
5) 1 bottle of gorilla glue, box of 1-1/2 inch deck screws $10.00
6) 2 hinges - $5.00
7) pre-drill holes to prevent melamine from cracking

Electronic components:
1) 3pc - old work outlet boxes $5.00
2) 3pc - Dimmer switches $15.00
3) 3pc - switch plates - $3.00
4) 3pc - extension cords - $6.00
5) 1pc - power strip outlet - $5.00
6) 1pc - 24"x4" flexwatt heat tape - $5.00
7) 2pc - 12"x11" flexwatt heat tape - $7.50
8) 3pc - flexwatt connector sets - $7.50
9) 3pc - Zoomed thermostats - $21.00
10 1 - roll of fasson aluminum tape - $?

Total - $160.00

P1010088.jpg

Assembly1.jpg

Assembly2.jpg

Shelves.jpg

back.jpg

electronicsmount.jpg

leftsideandcenterupright.jpg

rightside.jpg

topandbottom.jpg
 
Back
Top