• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

Modifying a screen lid

The Cat

The Cat

New member
I want to reuse an old 10 gallon that previously housed a hamster for a gargoyle gecko, so I’m planning on setting it on its side. The lid doesn’t exactly fit the tank so I’m gonna need to work on it before I can use it. Anyone have any tips for “tightening” the lid to fit the tank? It’s only half an inch-1inch too big so hopefully its fixable. This may be a stretch, but is there anyway I can modify it to have an opening door or something so I don’t have to take the lid entirely off every time I need access to the inside of the tank? Sort of like those zilla tanks with the little hatch, I suppose. Thanks y’all
 
That's a great question. Is it a standard size tank with the black plastic around the top? If so, check WalMart for lids. I picked one up for less than 20$ and it fits very tightly. Other than that, I'll just follow this thread.
 
You must log in or register to reply here.
Back
Top