• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

my incubator

B

baitman

New member
hi all.

as there are incubators being posted i thought i would show you mine...

first i went to the local tropical fish centre and got a polystyrene box....
IMG_5971.jpg


cut a window in the lid....
IMG_5972.jpg


tape a piece of glass in place...
IMG_5973.jpg


fix heat tapes in position using pins..
IMG_5980.jpg


wire up to a habistat(Or other stat) to be sure you dont cook the eggs, you can see the sensor is in the centre of the box, temp will be set at 90 degrees , the reason i set it that high is because inside the eggs tubs it will be up to 3 or 4 degrees cooler...
 
You must log in or register to reply here.
Back
Top