• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

Need Advice on New Set Up

D

Donald388

New member
Below is my new set up for my three baby corns.

Each box contains aspen bedding, hide and a small water dish. All three have temps around 80 on the hotter side and 75 on the cooler side.

My issue with this set up is the humidity. The humidity in my house is currently 30% (not terribly comfortable). It was higher but i turned off my humidifer after I found that the humidity in one of the snake boxes was 90%. That was two days ago.

Does anyone have any hints/tips on how to lower the humidity in the boxes? lowering the humidity in my home only reduced the humidity in the boxes to about 85%.

photo.jpg


photo1.jpg
 
Go to home depot get a really fine wire mesh, cut hole in container, hot glue it in place. Also remove the water from the warm side if its there.
 
If you want to reduce the humidity in the bins, you're going to need to increase ventilation, either by drilling several air holes, or like mentioned, convert the lids to have screen mesh in the top.
 
You must log in or register to reply here.
Back
Top