• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

New DIY Viv

D

Dragon666

New member
Hi All i am getting a viv made up its going to be 2 in one on top of each other the questions i have is heating i have got a ceramic heater and a heat mat i am planning on putting the ceramic on the bottom one and heat mat on the top one and of course using a thermostat just wondering if this would work or has any body got any ideas of setting it up a different way thanks
 
heat travels up. so id put the che on the top on and heat pad on the bottom. i think youll need more than 1 thermostat to control both though. or just get 2 of the same heat sources to make it easier to control.
 
You must log in or register to reply here.
Back
Top