• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

Okeetee + Normal...?

dan803

dan803

Born this way
It's an incredibly stupid question, I know. But If I bred my normal to an Okeetee what would the results be? I know an Okeetee is a normal, just a really nice one. So would breeding them result in so-so normals? Maybe a little more contrast and borders than a typical normal but not quite an Okeetee? I'm just curious. I'm sure somebody knows.
 
Mostlikely you would get standard normals, if you were lucky you might see some increase in width of borders, but not usually until F2 or F3.
 
Normals. The only way you'd get thicker borders in the F2 and F3 would be by selectively breeding the thickest borders in each clutch.
 
You must log in or register to reply here.
Back
Top