• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

Refresh my memory about temps

the probe for my thermostat sits under the substrate, however the thermometer sits above it and it usually reads between 82-84...

i must be doing something right huh....
 
The temperature on the glass is what you don't want to let get too high. I try to keep mine at 86 or below, and I don't even measure the temp on the substrate (only on the glass).
 
You must log in or register to reply here.
Back
Top