• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

sealing diy hides

IronOutTheIrony

IronOutTheIrony

IronOutTheIrony
So I have my first group of sculpty hides in the oven! I bought a pound of white, and two ounces of black and brown to give them a swirled look. Hopefully they look as good coming out as they did going in!

To the people that have worked with sculpty, what did you use to seal it? I read polyurethane is good...but oil or water based? Sculpty makes a glaze to put over finished work, but I'm afraid to use it since it has so many toxic warnings on the label. Any feed back would be wonderful! :)
 
You must log in or register to reply here.
Back
Top