• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

Thermostat/Thermometer Probe Placement

M

mauler5858

New member
I picked up 2 digital thermometers with probes and a hydro farm thermostat on the way. I have picked 1 theometer per side, the thermostat for the heat mat, and I have a hydrometer/thermostat at the bottom center for air temp.

My question is where exactly do I need to put the three probes, and do they need to be on the inside or the outside? Also is bottom center the best location for the therm/hydrometer??
 
The thermostat probe and one temp probe go inside, in the center of the UTH.

The cool side probe goes anywhere on the cool side. I put it under the aspen. Where the snake would be.

It takes the UTH about a day to stabilize. Make very gradual adjustments.
 
You must log in or register to reply here.
Back
Top