• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

undertank heater question

kensei

kensei

New member
I'm looking to get another corn (or possibly 2) and I don't think I have enough space at the moment to get more 20L tanks. If I decide to go down the 28qt sweater box/Rubbermade route, I was wondering if I could just stick an undertank heater (with thermostat) to the bottom and if that would be sufficient for heating. One of my initial concerns with this was whether or not the undertank heater would melt the plastic or if the container would get too hot inside with the lid on. Thanks.
 
You must log in or register to reply here.
Back
Top