• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

UTH placement in spilt viv?

Nataiani88

Nataiani88

New member
I just bought a 40 gal breeder tank that I'm gonna add a divider to for my two corns. My question is how do I set up the UTH? Do I have one large one in the center where the divider is? Or a smaller one on opposite ends of the viv?


Sent from my iPhone using Tapatalk
 
I do this, I split the UTH between two tanks and use a probe thermometer in each. The thermostat (I use a cheap dimmer slide to control the heat).

I would put the the larger UTH between the tanks, that way the snakes are monitored all the time with the probe thermometer.
 
Last edited:
I have a divided tank (with a corn and ball python; the ball python needs more heat) so I have a larger UTH and put it under the divider. It will save you money on UTHs and thermostats, that's for sure!
 
You must log in or register to reply here.
Back
Top