• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

Vines.

Suction cups can work well when they are small.

Or you can attach it to the top of your viv, either hook it in the lid itself or have something hanging down that it attaches to. Don't use tape. I wouldn't suggest gluing it or anything permanent like that.
 
Yep, agree with acetone, I use suction cups, I have also purchased pre manufactured one with suction cups already attached and I have also used Velcro on some things also.
 
suction cups work fine but if they can't hold the weight of your snake you can use a hot glue gun. If you decide you want to remove them and place them elsewhere just take a butter knife and apply a little force between the glue and the wall and it'll pop right off. Also if you've got a wooden viv and you can't get any suction or the glue won't hold, a staple gun will make sure they hold up against most snakes weight.
 
You must log in or register to reply here.
Back
Top