• Hello!

    Either you have not registered on this site yet, or you are registered but have not logged in. In either case, you will not be able to use the full functionality of this site until you have registered, and then logged in after your registration has been approved.

    Registration is FREE, so please register so you can participate instead of remaining a lurker....

    Please be certain that the location field is correctly filled out when you register. All registrations that appear to be bogus will be rejected. Which means that if your location field does NOT match the actual location of your registration IP address, then your registration will be rejected.

    Sorry about the strictness of this requirement, but it is necessary to block spammers and scammers at the door as much as possible.

What paint & silicone is safe for snakes?

Minwax polycrylic. Any paint I'd use I would go over with a couple coats of polycrylic. This is what I am doing for some projects I am working on for my snakes. Aquarium sealant would also be safe.
 
Any 100% silicone without mold inhibitors is fine. I will need to fully dry and cure before your reptile can be around it. If you can smell it (smells like vinegar) it's not ready yet.

Krylon fusion paints are safe and Minwax Spar Urathane is also safe. Again they need to fully dry and cure before use.

Also glossy paint/clear makes objects slippery and hard to grip, which may or may not pose a problem depending on what you are making :)
 
You must log in or register to reply here.
Back
Top